MIKE B

[Eric Lewis]

on the 450 se v2, how is your elevator servo layed out so it doesnt hit the torque tube gears?

[MikeB]

You trim all the excess plastic you can off the servo arm till you have about .5mm clearance between the gear and servo arm.

Its a close fit for sure. I hand filed, checked clearances, hand filed some more till it had will travel without hitting the gear.

I also have the DS285 JR's on it and the output shaft may be positioned differently than what your using.

[Eric Lewis]

thanks, didnt know if we could shave some of that off or not

[chad bidwell]

it is a close fit in there