Trex 500 motor rebuild

[BrokenRotor]

Does anyone know how to disassemble the stock motor that comes with the Trex 500? Last week when I crashed mine a couple of the wire going into the case were cut through the insulation. I want to replace them, or at least heatshrink each wire seperately.

I do not see any screws holding the motor together.:arrrggghhh:

Please help, I can't really afford a new motor.:(

Thank you.:)

[Strobe]

Hope this helps, They're is also a video on how to repair in that post.

http://www.helifreak.com/showthread.php?t=76264

[BrokenRotor]

Hope this helps, They're is also a video on how to repair in that post.


Thanks Strobe. The video shows exactly how to take it apart. Again your knowlege has been a great help.:D:D

With any luck I should have it in the air tomorrow sometime.

[BrokenRotor]

Well I took the motor apart, check the wires as best I could, put heatshrink on each of the three wires, then reassembled it. I think I caused some bearing damage somewhere in the rebuilding process.:doh: So now I will probably need to rebuild it again with new bearings this time. But at least it still works.:)

Strobe do you have any stock motors you would be willing to sell?:)

My fun bucket is full so, have a great night.:D

[Strobe]

Strobe do you have any stock motors you would be willing to sell?:)

Yes I do !

[Eric Lewis]

how about a pimped 0ut 500 fbls and neu motor?